Avon EX090 & EX120 Turnstiles are an ATEX / IECEx certified product that have been designed for pedestrian entry point control into hazardous areas which are potentially susceptible to explosive atmospheres.
Designed and manufactured in the UK, Avon EX Turnstiles will provide security and enhance any pedestrian entrance to primarily oil and gas / chemical works sites without creating an ignition source.
This is a security product but has been specifically designed to mitigate the Health and Safety risks associated with sites with the potential to create explosive atmospheres.
Key features & benefits
Available in a range of operating modes they can be interfaced with all forms of ATEX / IECEx certified access control systems.
Turnstile systems are manufactured from mild steel sections and sheets which are finished in a high specification multi-coat and anti-static paint system (colour – red RAL3001 as standard but other colour options are available on request).
The Turnstile rotors are constructed from 316 stainless steel 40 pipe (38mm x 3.7mm) and are spaced at 194mm (centre to centre of rotors)
Where the turnstile control point is remote from the installation, we strongly recommend the fitting of a recordable CCTV system.
Industries requiring intrinsically safe ATEX & IECEx certified equipment
Datasheet – Avon EX090 Turnstiles
Datasheet for Avon EX090 Turnstiles – full height pedestrian turnstile systems certified to operated in IECEx & ATEX group 2 category 2 (zone 1) designated hazardous areas.
Datasheet – Avon EX120 Turnstiles
Datasheet for Avon EX120 Turnstiles – full height pedestrian turnstile systems certified to operated in IECEx & ATEX group 2 category 2 (zone 1) designated hazardous areas.
|Basic Power requirements:||230v, 1ph, 6amp, 50HZ (Other voltages are available on request)|
|Turnstiles Type:||90° 4 bar rotor system / 120° 3 bar rotor system|
|Rotor thickness and spacing:||40 pipe (38mm x 3.7mm)|
|Power fail operation:||The turnstile controller can be configured to free wheel in one or both directions on power fail or fire alarm signal.|
|Walkway Height / width:||1.9m / 590mm|
|ATEX protection level:||II 2G Ex h IIC T4 Gb|
|IECEx protection level:||Ex h IIC T4 Gb|
|Construction:||INVER S.P.A. 40496 NP ESD Rosso 3001 (red), thickness 80 microns (anti-static paint).|
|Installation:||For installation, connection points are provided in an EX e enclosure (containing termination panel and ATEX / IECEx electrical isolator) located at the bottom corner of the unit.|
Please note that any access control systems / push buttons etc. must be fully compliant with the same ATEX / IECEx classifications if mounted on or in the vicinity of the equipment.
What is the risk of my workplace being subjected to a serious violent hostile act? I guess the place to start this assessment is to take a view on how…
In 2007, a vehicle laden with explosives was driven at speed into the façade of the departure terminal at Glasgow Airport, with the intention to cause mass casualties; luckily the…